Miraflex Membrane: Miracote Miraflex 1 Gallon
Miracote MiraFlex Membrane A is a single-component, water-based polymer emulsion waterproofing membrane designed for use beneath tile, marble, quarry tile, seamless composition flooring, and other protected finishes. It can also be used in below-grade and between-slab applications, as well as beneath Miracote flooring and deck systems.
MiraFlex Membrane A is based on styrene-butadiene latex and dries to form a tough, water- and vapor-resistant film. The formulation contains no solvents, is low odor, and is suitable for use in conjunction with potable water systems, including tank lining applications.
The membrane provides strong adhesion and can be applied over properly prepared concrete, tile, and metal. Its fluid-applied design allows it to conform to irregular shapes and form a continuous, monolithic waterproof layer across floors, bases, and curbs without separate adhesives. It also offers greater impact resistance than many membrane systems and helps reduce reflective cracking caused by substrate movement.
A standard installation produces a 25-mil dry film using two coats, while fabric-reinforced applications can reach approximately 30 mils dry. Laboratory testing shows the membrane can bridge cracks up to 1/8 inch under test conditions, though the manufacturer recommends designing around a more conservative 1/16-inch crack width. The cured membrane also provides 580% elongation, helping it accommodate minor substrate movement.
MiraFlex Membrane A dries quickly, becoming touch-dry in approximately 1–2 hours and fully dry in about 12 hours. Typical coverage is about 64 sq. ft. per gallon at 25 mils wet film thickness, and fabric-reinforced applications require approximately 20% more material. The product is supplied ready to use and does not require mixing.
Installation begins with a clean, properly prepared substrate. A primer coat of MiraFlex Membrane A diluted 50% with water is applied first, followed by two membrane coats to achieve the required dry-film thickness. The completed installation should be water-tested before covering. The membrane is not recommended for use directly over expansion or seismic joints.



