Description
Henry 545 Aquatac Primer Usage:
Used as a primer for self-adhered membranes such as Henry Blueskin WP200 when applied to masonry, concrete, wood, drywall and metal.
Application
Surface Prep: All surfaces must be dry and free from dust, dirt, grease, oil or other foreign matter.
Apply: Henry 545 Aquatac Primer is applied by roller at a rate up to 500 sq. ft. per gallon depending on the porosity and texture of the surface and allow to dry. Airless, air assist, or air spray equipment may also be used. Not suitable for use with a garden type sprayer. Pour primer from container into sprayer and spray fine mist over the entire substrate. Allow primer to dry thoroughly before applying membrane. Primer surfaces not covered by membrane during the same working day must be reprimed. Henry 545 Aquatac Primer is intended to be used as supplied and should not be diluted.
Clean Up: For uncured film use water. Use mineral spirits for cured films.
Precautions
Protect from freezing during shipping, storage and application. Apply under dry conditions above 25 °F (-4 °C). Avoid freezing. Store product above 32 °F (0 °C).
Storage
Store pails on original pallets or elevated platform. Protect from weather or store in an enclosed area not subject to heat over 120 °F (49 °C). In cold weather, it is recommended to warm pails to 50 °F (10 °C) or above prior to application to assure adhesion to substrate.
Caution
In case of eye contact, open eyelids wide and flush immediately with plenty of water for at least 15 minutes. Seek medical attention. Use protective measures to avoid contact with eyes and skin. If swallowed, seek medical attention immediately. In case of accidental injection by power spray equipment, seek medical attention immediately. Dispose of container and unused contents in accordance with local, state, and federal regulations. Close container after use.