Vulkem 360 NF is a low odor, V.O.C. compliant, water-cured, rapid setting polyurethane product that possesses tenacious adhesion to clean and dry concrete, wood and metal. Questions? Contact Us.
When mixed with aggregate, Vulkem 360NF can be used to slope decks and to fill in low and spalled concrete. Vulkem 360NF is compatible for use with Tremco topcoats as a pedestrian or traffic waterproof deck coating system. (See Tremco published application instructions for deck coatings.)
Immediately available from your local Tremco Sales Representative.
Sloping and Patching Application
Thoroughly mix Vulkem 360NF in original pail prior to adding water. Thoroughly mix 5 parts of Vulkem 360NF base with 1 part of water (by volume).
In a rotating-bucket mixer, begin adding sand to the mixed Vulkem 360 NF until desired consistency is reached. Use 40-50 mesh silica sand or aluminum oxide for optimum workability. Trowel the mixture in the area to be filled or sloped. The following table provides a general guideline for use in high traffic areas.
Concrete shall be water-cured and attain a 4000 psi minimum compressive strength. Concrete finish shall be a light steel trowel followed by a fine-hair broom, or equivalent ICRI #2-#4 finish. Moisture content in the concrete must
be lower than 4.5% as measured by a Tramex CME 4 Moisture Meter. Depending on concrete construction and job site location, additional concrete testing may be required. Please contact your local Tremco Sales or Technical
Representative. Please refer to the Vulkem 360NF/950NF/951NF Application Instructions for complete application details. The techniques involved may require modification to adjust to the jobsite conditions. Consult your Tremco Sales Representative or Tremco Technical Service for site conditions and requirements.
Fire Rated Assemblies:
• ANSI/UL790 – Standard Test Methods for Fire Tests of Roof Coverings
• CAN/ULC-S107 – Methods of Fire Tests of Roof Coverings