EUCO Quick Joint UVR 10G Unit: Polyurea Joint Filler
EUCO Quick Joint UVR represents a new generation of polyurea technology with features and benefits unlike any other polyurea joint filler on the market. EUCO Quick Joint UVR resists fading from ultraviolet light greater than any existing product. It is a fast-setting, semi-rigid polyurea, primarily used for filling construction and control joints in industrial and commercial concrete floors. EUCO QWIKjoint UVR can be shaved flush with the floor shortly after placement or up to 24 hours later. QWIKjoint UVR supports and protects joint edges from heavy loads and wheel traffic, reducing spalling of the joint edges. QWIKjoint UVR is available in 33 standard colors and in a Neutral Base, that can be colored on site with EUCLID UNIVERSAL COLOR PACKS; available in the same 33 colors. Questions? Contact Us.
• Concrete construction & control joints
• Crack and joint repair for old floors
• Industrial and commercial floors
• Freezer floors
Surface Preparation: All joints to be filled must be clean and dry. All oil, dirt, debris, paint and any other material that may be a bond breaker must be removed. The final step in cleaning must be the complete removal of all residue with a vacuum cleaner and oil-free compressed air. All joint facings must possess an open surface texture with all curing compounds and sealers removed. If this product will be used for filling floor cracks, the cracks must be routed out and cleaned before filling. For proper installation, all edges must be squared off.
Joint Backing: To provide proper load transfer, EUCO QWIKjoint UVR must be filled full depth of the joint or crack. Do not use backer rod or other fill material for the purpose of reducing volume. Dried silica sand, 1/16” to 1/8” (1.5 to 3 mm), may be used to fill the crack at the bottom of the joint to prevent materal loss through the slab.
Finish your job with Euclid Epoxies:
Euclid Eucothane 3 gallon
Duralflex Fastpatch Epoxy Repair Mortar
Euco 700 Joint Filler
Priming: EUCO QWIKjoint UVR does not require a primer before application. Preparation of 10 gal (37.9 L) units
Mixing: Due to its extremely fast set time, EUCO QWIKjoint UVR requires machine mixing and placing. **Slowly pre-mix Part B separately before using with a slow speed drill and mixing paddle for 2 to 3 minutes. Do not whip air into the Part B while mixing. Follow mechanical pump manufacturer’s equipment instructions for operation.
NOTE: If EUCO QWIKjoint UVR is to be stored in the dispensing pump overnight, place a sheet of plastic wrap
directly on top of the liquid material in each tank to prevent exposure to air.