Self Leveling SL 2 MasterSeal is a multi-component, self leveling, elastomeric polyurethane sealant that is mixed and poured in place. When cured, it forms a tough, resilient joint seal that resists penetration, abrasion, and remains flexible when exposed to weather and aging. 1.5 gal pail. Questions about Self Leveling SL 2 MasterSeal? Contact us
MasterSeal SL Highlights
- abrasion resistant to help handle pedestrian and vehicular traffic
- Joint movement capability ±25% provides excellent flexibility for keeping moving joints weathertight
- Weather resistant, producing long-lasting weathertight seals
- easy to gun and tool, speeding up application and making neater joints
- masterSeal 905 accelerator available for use in cold climate applications to help speed initial cure
- no primer required for most construction materials, lowering installation costs
- Wide temperature-application range makes masterSeal Sl 2 suitable for all climates
- Ul listed; Passes 4-hour, 4-inch, fire and hose stream test when used with Ultra Block or mineral wool
- Suitable for water immersion with documented performance in wet areas
- chemical cure allows for faster turnaround time
- Bulk packaging results in less waste
- long pot life offers extended working time
- Formulated to withstand pedestrian and vehicular traffic
HoW to AppLY
1.the product may be used in sealant joints designed in accordance with SWR institute’s Sealants – The Professional’s Guide.
2. In optimal conditions, the depth of the sealant should be 1/2 the width of the joint. the sealant joint depth (measured at the center) should always fall between the maximum depth of 1/2″ and the minimum depth of 1/4″. refer to table 1.
3. In deep joints, the sealant depth must be controlled by closed cell backer rod or soft backer rod. Where the joint depth does not permit the use of backer rod, a bond breaker (polyethylene strip) must be used to prevent three-point bonding.
4. To maintain the recommended sealant depth, install backer rod by compressing and rolling
it into the joint channel without stretching it lengthwise. closed cell backer rod should be about 1⁄8″ (3 mm) larger in diameter than the width of the joint to allow for compression. Soft backer rod should be approximately 25% larger in diameter than the joint width. the sealant does not adhere to it, and no separate bond breaker is required. Do not prime or puncture the backer rod.